FLIC Luminary Installation & Setup

*for installing luminaries on parapet walls, click here.

For Electric Light Strings:

1. Remove the luminarias from the reusable shipping/storage carton. To un-stack or "de-nest" the luminarias it is easiest to set them on a flat surface, clamp the bottom luminary between your feet and gently pull up on the top luminary.

2. Attach the light string to each luminary.

• Remove the light string from the box and straighten out the cord.
• Hold the socket underneath a luminary so that the socket is aligned with the bulb hole in the luminary. Put the light bulb base through the bulb hole and then screw the bulb into the socket.
• Repeat for each luminary.
• When setting out the luminarias run the wire in the wire channel under each luminary. Note: duct taping the wire into the wire channel with two small pieces of duct tape will make placement of the luminary easier on flat surfaces such a sidewalks, etc.

3. Hold down method:

• Sand, gravel, or kitty litter - use 1 1/2 cups or up to the level of the candle base. -OR-
• Stakes - use one or two per luminary.

4. Place the luminarias in the desired location.

5. Plug the luminary light string into an electrical outlet and turn on the luminarias.

6. Clean Up & Storage:

• You may leave lights and hold down material in FLIC Luminaries for next use. The luminarias will stack or "nest" with the light string attached.

Electric luminary safety precautions:

1. Read and follow all safety instructions, all use and care instructions, and all user servicing instructions that are included with the light string.

2. Luminarias should not be left unattended.

For Candles:

1. Remove the luminarias from the reusable shipping/storage carton. To un-stack or "de-nest" the luminaries it is easiest to set them on a flat surface, clamp the bottom luminary lengthwise between your feet and gently pull up on the top luminary.

2. Hold down method:

• Water - use 1 1/2 cups or up to the level of the candle base. -OR-
• Gravel, sand or kitty litter - use 1 1/2 cups or up to the level of the candle base. -OR-
• Stakes - use one or two per luminary.

3. Place the luminarias in the desired location.

4. Rinse inside of candle holder with water before inserting candle. This will keep wax from sticking to candle holder.

5. Place a candle holder and a candle in each luminary within the circular ring on the candle pedestal.

6. Light the luminarias at the desired time.

7. Clean up:

• Properly dispose of the used candles & save the candle holders for reuse. Candle holders can be reused up to 5 times.
• Empty the luminaries of water if water is used as hold down material.
• Note: You may leave hold down material in FLIC Luminaries for next use. The luminaries will stack or nest.

8. Storage:

• The original shipping carton is designed to store the luminaries until the next use.

Candle luminary safety precautions:

1. Luminarias should only use candles on a level surface. They can be used indoors or outdoors, but extra caution is advised to prevent accidents.

2. Luminarias should not be placed on any flammable surface.

3. Luminarias should not be placed near anything that is flammable.

4. Luminarias should not be left unattended.

5. Don't attempt to remove candle or candle holder if molten wax is present.

Helpful Hint:

To clean candle holders, use teaspoon to scoop out unburnt wax and wick holder. Candle holders can be reused but should be inspected after each use for possible damage. Do not reuse damaged candle holders.

For LED Tea Lights:

1. Remove the luminarias from the reusable shipping/storage carton. To un-stack or "de-nest" the luminarias it is easiest to set them on a flat surface, clamp the bottom luminary lengthwise between your feet and gently pull up on the top luminary.

2. Hold down method:

• Sand, gravel, or kitty litter - use 1 1/2 cups or up to the level of the candle base. -OR-
• Stakes - use one or two per luminary.

3. Place LED tea lights in each luminary within the circular ring on the pedestal.Turn tea lights on and off with the bottom switch on each tea light. Batteries are replaceable.